Service Details

  • Home
  • Service Details

Chinaware QC inspection services:


Most Chinaware like disks, plates, bowls, cups, mugs, vases etc. are made in Chaozhou Guangdong China. The onsite quality inspections of Chinaware will normally be inspected as follows:

INSPECTION CHECKPOINTS RESULTS COMMENTS
Packaging, safety and drop tests onsite OK
Product specs, and special requirements verifying NOT OK
Measurements & sizes inspections NOT OK
Aesthetic, visual defects, workmanship, surface and function checks OK
Quantity & assortment checks OK
On-site safety, regulation & function tests NOT OK
Labels, markings, logos & barcodes QC inspections N/A

For professional third party inspection services, the technical classifications are as below:

Chinaware QC inspection services

The Chinaware inspection checkpoints:

ON-SITE INSPECTION CHECK LIST COMMENTS RESULT
Perform a wobble test on a flat glass panel. Check both the top rim of the glass and the bottom.-There should be no wobbling of the base or the rim.-I PASSED
If the product is designed for use in a dishwasher and/or microwave oven, place it in a dishwasher and run the dishwasher for one cycle during the inspection period and also 10 minutes in the micro-wave oven.-If the product is designed for use in a dishwasher and/or microwave oven, place it in a
dishwasher and run the dishwasher for one cycle during the inspection period and also 10 minutes in the micro-wave oven.-S2
PASSED
Perform a fatigue test-On all adjustable parts. Do this 20 times.-S2 FAILED
Test the strength of the handle.--S2 PASSED
Check if items stand properly when pieces are stacked up, if this test fail, please state the cause clearly on inspection report and take photos-
1)Stack the products (60 pieces for the plate/reference and 12 pieces for bowl/reference and cup/reference );
2) Ensure they can stack properly and do not wobble or tilt over-S2
PASSED
Check capacity (volume) by weighing the item or by using a capacity gauge ( the mug, bowl and the container claimed with the volumn)-The results must conform with the specifications.-S2 N/A
Test the item for water leakage during the entire inspection period.-Fill the item with water then place onto a paper to check there is no leakage at all.-S2 FAILED
Compare the inspection sample with the approval sample.-II PASSED
Perform a fitting test check-The lid should fit the base well.-II N/A
Hand washing test -- --Wash the product with cotton fabric in cold water of room temperature (about 20--35degree) and hot water of tempertature (about 80 -- 90 degree) -- During washing, dip product into the water and wiping the whole surface of the product -No color should be removed from the item’s surface during the test and no printing, markings or paint should fade.-3 pcs PASSED
Test the fit of the lid. and lid can not falls off when the teapot is tilted toward 90 degrees-If the item has a lid - The lid should fit well.-S3 FAILED

3rd party preshipment products goods factory onsite inline final Random AQL PSI TPI FRI DUPRO third party on-site in-line pre-shipment QA check quality control assurance in China India Vietnam Thailand Malaysia Bangladesh Taiwan.

 

Menu
x