Service Details

  • Home
  • Service Details

Saucers quality inspection:


Most Chinaware like saucers disks, plates, bowls, cups, mugs, vases etc. are made in Chaozhou Guangdong China. The onsite quality inspections of Saucers will normally be checked as below:

INSPECTION CHECKPOINTS RESULTS COMMENTS
A. Quantity verify N/A
B. Shipping marks & packing NOT OK
C. Labels, logos and colors OK
D. Styles & measurements NOT OK
E. Onsite safety and function tests OK
F. Special requirements NOT OK
G. AQL workmanship
(Visual defects)
OK

For third party quality inspection services, the technical classifications are as below:

saucers Quality inspection

The Saucers inspection checkpoints:

ON-SITE INSPECTION CHECK LIST COMMENTS RESULT
Perform a wobble test on a flat glass panel. Check both the top rim of the glass and the bottom.-There should be no wobbling of the base or the rim.-I N/A
Check if items stand properly when pieces are stacked up, if this test fail, please state the cause clearly on inspection report and take photos-
1)Stack the products (60 pieces for the plate/reference and 12 pieces for bowl/reference and cup/reference );
2) Ensure they can stack properly and do not wobble or tilt over-S2
FAILED
Compare the inspection sample with the approval sample.-II PASSED
Test the strength of the handle.--S2 PASSED
Check capacity (volume) by weighing the item or by using a capacity gauge ( the mug, bowl and the container claimed with the volumn)-The results must conform with the specifications.-S2 PASSED
Hand washing test -- --Wash the product with cotton fabric in cold water of room temperature (about 20--35degree) and hot water of tempertature (about 80 -- 90 degree) -- During washing, dip product into the water and wiping the whole surface of the product -No color should be removed from the item’s surface during the test and no printing, markings or paint should fade.-3 pcs PASSED
Test the item for water leakage during the entire inspection period.-Fill the item with water then place onto a paper to check there is no leakage at all.-S2 N/A
Perform a fatigue test-On all adjustable parts. Do this 20 times.-S2 PASSED
Perform a fitting test check-The lid should fit the base well.-II PASSED
Test the fit of the lid. and lid can not falls off when the teapot is tilted toward 90 degrees-If the item has a lid - The lid should fit well.-S3 PASSED
If the product is designed for use in a dishwasher and/or microwave oven, place it in a dishwasher and run the dishwasher for one cycle during the inspection period and also 10 minutes in the micro-wave oven.-If the product is designed for use in a dishwasher and/or microwave oven, place it in a
dishwasher and run the dishwasher for one cycle during the inspection period and also 10 minutes in the micro-wave oven.-S2
FAILED

3rd party preshipment products goods factory onsite inline final Random AQL PSI TPI FRI DUPRO third party on-site in-line pre-shipment QA QC check control assurance services in China India Vietnam Thailand Malaysia Bangladesh Taiwan.

 

Menu
x