Service Details

  • Home
  • Service Details

Saucers onsite inspection:


Most Chinaware like saucers disks, plates, bowls, cups, mugs, vases etc. are made in Chaozhou Guangdong China. The onsite quality inspections of Saucers will normally be checked as below:

INSPECTION CHECKPOINTS RESULTS COMMENTS
A. Quantity inspection OK
B. Shipping marks & packing OK
C. Labels, logos and colors OK
D. Styles & measurements NOT OK
E. Onsite safety and function tests OK
F. Special requirements N/A
G. AQL workmanship
(Visual inspections)
NOT OK

For third party quality inspection services, the technical classifications are as below:

saucers onsite inspection

The Saucers inspection checkpoints:

ONSITE INSPECTION CHECK LIST COMMENTS RESULT
Perform a fitting test check-The lid should fit the base well.-II PASSED
Test the fit of the lid. and lid can not falls off when the teapot is tilted toward 90 degrees-If the item has a lid - The lid should fit well.-S3 FAILED
Compare the inspection sample with the approval sample.-II PASSED
Hand washing test -- --Wash the product with cotton fabric in cold water of room temperature (about 20--35degree) and hot water of tempertature (about 80 -- 90 degree) -- During washing, dip product into the water and wiping the whole surface of the product -No color should be removed from the item’s surface during the test and no printing, markings or paint should fade.-3 pcs PASSED
Check capacity (volume) by weighing the item or by using a capacity gauge ( the mug, bowl and the container claimed with the volumn)-The results must conform with the specifications.-S2 PASSED
Perform a fatigue test-On all adjustable parts. Do this 20 times.-S2 PASSED
Check if items stand properly when pieces are stacked up, if this test fail, please state the cause clearly on inspection report and take photos-
1)Stack the products (60 pieces for the plate/reference and 12 pieces for bowl/reference and cup/reference );
2) Ensure they can stack properly and do not wobble or tilt over-S2
FAILED
If the product is designed for use in a dishwasher and/or microwave oven, place it in a dishwasher and run the dishwasher for one cycle during the inspection period and also 10 minutes in the micro-wave oven.-If the product is designed for use in a dishwasher and/or microwave oven, place it in a
dishwasher and run the dishwasher for one cycle during the inspection period and also 10 minutes in the micro-wave oven.-S2
PASSED
Perform a wobble test on a flat glass panel. Check both the top rim of the glass and the bottom.-There should be no wobbling of the base or the rim.-I PASSED
Test the item for water leakage during the entire inspection period.-Fill the item with water then place onto a paper to check there is no leakage at all.-S2 PASSED
Test the strength of the handle.--S2 FAILED

3rd party preshipment products goods factory inline final Random AQL PSI TPI FRI DUPRO third party on-site in-line pre-shipment QA QC check quality control assurance services in China India Vietnam Thailand Malaysia Bangladesh Taiwan.

 

Menu
x